Phaser Color Laser Printer Service Manual. Parts List. Serial Number Format. Changes to Xerox products are made to accommodate improved. Phaser Color Laser Printer Service Manual xv. Table of Contents. Service Terms. Phaser service manual · XEROX Phaser service manual. Product documentation for Phaser Phaser Support & Drivers. Customer Technical Support. Fast Track to the Expert > U.S. &.
|Published (Last):||19 April 2014|
|PDF File Size:||15.60 Mb|
|ePub File Size:||4.50 Mb|
|Price:||Free* [*Free Regsitration Required]|
Go to step 3. The Demo page will be printed in duplex mode when a Duplex Unit is installed.
Phaser 6280 Support & Drivers
Page 72 Drum to the paper. Page Move the Sensor up and down and check the information on the Control Panel display.
Check the Image Processor Board. Verify that the Duplex Motor is working and the gear is rotating. Press the Cancel button to stop the Tray 3 Turn Clutch test. Reseat the Print correct installation. Page The Processing Configuration Page contains: Transfer Unit page 2.
Xerox phaser 6280 service manual to match the sercice in the tray. Remove the Optional Hard Drive if installed page Print the Configuration page and Go to step 2. Page Check the Humidity Sensor signal. Vertical Stripes page Pattern Iot Compare the print with following chart to determine the problem. Page The Retard Roller is pushed toward Feed Roller by spring pressure, and controlled by the Friction Clutch with which it is coupled.
Slide the Left Side Cover at an angle toward the rear to remove it. Duplex Jam Sensor PL K Drive Assembly pl8. Release the notches on the Right Sevice from the holes on the Optional Frame.
Remove 1 screw 10 mm securing the LED Assembly. Parts List Parts List 3. Table of Contents Add to my manuals Xerox phaser 6280 service manual.
Verify that the Yellow Toner Motor is running and the gear is rotating. Page Release the convex part on the left and right xerox phaser 6280 service manual of the Tray 3 Feeder from the flange on the left and right sides of the Frame to remove the Tray 3 Feeder. At that time the revision digit will be rolled. Release the ground wire of the Power Switch from the clamp. Do not expose the Print Cartridges to light for more than 5 minutes. Short the pins on the MCU Board.
Xerox Phaser 6280
Jam At Registration Roll Clean the paper Feed and Retard Rollers in the paper tray and tray slot using a slightly damp water only lint free cloth. Is the Transfer Unit correctly Go to step The arrow indicates the direction of signal. Ensure your appropriate downloading cable option Ethernet or USB is connected. Cleaning Paper, toner, and dust xerox phaser 6280 service manual can accumulate inside the printer and cause print-quality problems such as Smearing or Toner Specks.
XEROX PHASER SERVICE MANUAL Pdf Download.
Hard Xero Assembly pl9. Page Guaranteed Print Area: Load Tray 3 paper Mismatch 1. Page Verify that the Magenta Toner Motor is running and the gear is rotating.
The Demo Page is printed in color from selected paper tray. The Retard Roller is pushed toward Feed Roller by spring pressure, and controlled by the Friction Clutch with which it is coupled.
Compare the print with following chart to determine the problem.