ADC0808 PDF

The ADC IC is a commonly used ADC module for projects were an external ADC is required. Find ADC pin diagram, features & datasheet. ADC – A/D converters, used to convert analog signal to digital signals, like ADC IC, ADC IC, pin configurations and interfacing with microcontroller . The ADC/ADC is an 8 bit ADC that also contains an 8 channel multiplexer. The FPGA used in this case was the Altera 10k20RC that is found on.

Author: Gorisar Garn
Country: Comoros
Language: English (Spanish)
Genre: Art
Published (Last): 11 November 2018
Pages: 424
PDF File Size: 8.43 Mb
ePub File Size: 11.55 Mb
ISBN: 858-5-63429-768-6
Downloads: 61141
Price: Free* [*Free Regsitration Required]
Uploader: Mazur

Analog Channel 1 to 5. It is recomended that the source resistance not exceed 5kohms for operation at 1. I have changed some modifications too but still its not working. It can be tied to the Start line if the clock is zdc0808 under kHz. As with all control signals it is required to have an input value of Vcc – 1. The obtained value is 2. Atmospheric Vortex Engine Twister Power.

ADC Interfacing With | EmbeTronicX (Embedded Tutorials Zone)

Top rail of Reference voltage. Be afc0808 to consult the manufactures data-sheets for other chips. This is an address select line for the multiplexer.

Most Related  MAPA RUTERO DE CHILE PDF

And like wise for other channels. That is for every increase of A 9 volt battery and a 5 volt voltage regulator namely are used for powering the circuit. Interface SD Card with Arduino.

Get Our Weekly Newsletter! ADC gives ratio metric conversion output at its output pins.

ADC0808 IC

The source resistance must be below 10kohms for operation below kHz and aec0808 5kohms for operation around 1. And show on LCD as name Ch2. The default step size is This means that in order to get it to work, there is a total of seven control signals that must be sent from the FPGA.

The right input analog voltage can be given to pins from IN1 to IN7, but the IC can read the voltage of avc0808 one channel at a time.

ADC Technical Data

Connect to ground of the circuit. It is a control signal from the FPGA, which tells the converter when to start a conversion. Skip to main content.

End of conversion; output pin; goes low when the conversion is over. Some external ADC chips are ,, and there are many more.

And the formula for radiometric conversion is given by: Input pin; a low to high pulse brings data to output pins from the internal registers at end of conversion. As you can see in the image the voltage value is 2. For a quick reference refer to table 2.

Most Related  ADVERBS DANIEL HANDLER PDF

All of the signals are explained below. At ac0808 speeds greater than that the user must make certain that enough time has passed since the ALE signal was pulsed so that the correct address is loaded into the multiplexer before a conversion begins. Top menu About Us Contact. The ADC needs some specific control signals for its operations like start conversion and bring data to output pins. Actually the code u have posted is not working i guess due to the initialization i think.

Access Denied

All control signals should have a high voltage from Vcc – 1. The source code provided was used to control an ADC where only 4 inputs were used, therefore, ADD C is tied to ground and so are the unused inputs. These three pins are used adx0808 select the channel.